![background image](http://html1.mh-extra.com/html/karcher/hd-1-8-14-ed/hd-1-8-14-ed_operators-manual_653912011.webp)
9.800-088.0 • REV. 0/08
11
PRESSURE
W
ASHER
OPERA
T
OR’S MANU
AL
OIL CHANgE RECORD
PREvENTATIvE MAINTENANCE
This pressure washer was produced with the best available materials and quality craftsmanship. However, you
as the owner have certain responsibilities for the correct care of the equipment. Attention to regular preventative
maintenance procedures will assist in preserving the performance of your equipment. Contact your dealer for
maintenance. Regular preventative maintenance will add many hours to the life of your pressure washer. Perform
maintenance more often under severe conditions.
general Inspection
Inspect the motor at regular intervals, approximately every 500 hours of operation,
or every 3 months, whichever occurs first. Keep the motor clean and the ventilation
openings clear. The following steps should be performed at each inspection:
WARNINg: Do not touch electrical connections before you first ensure that power
has been disconnected. Electrical shock can cause serious or fatal injury. Only
qualified personnel should attempt the installation, operation and maintenance of
this equipment.
1. Check that the motor is clean. Check that the interior and exterior of the mo-
tor is free of dirt, oil, grease, water, etc. Oily vapor, paper pulp, textile lint, etc.
can accumulate and block motor ventilation. If the motor is not properly ven-
tilated overheating can occur and cause early motor failure.
. Check all electrical connectors to be sure that they are tight.
Lubrication & bearings
Bearing grease will lose its lubricating ability over time, not suddenly. The lubricating
ability of a grease (over time) depends primarily on the type of grease, the size of
the bearing, the speed at which the bearing operates and the severity of the operat-
ing conditions. Good results can be obtained if the following recommendations are
used in your maintenance program.
Type of grease
A high grade ball or roller bearing grease should be used. Recommended greases
standard service conditions are: Shell Dolium R (Factory installed) or Chevron
SRI
Pump Oil
Inspect
Daily, Inspect the oil level
Change
After first 50 hours, then every 500 hours
or annually
Replace High Pressure Nozzle
Every 6 months
Replace Quick Connects
Annually
Replace Clean Water Screen/Filter
Weekly
Replace HP Hose
Annually if there is any sign of wear
Grease Motor
Every 10,000 hours or annually
Date Oil Changed
Month/Day/year
Estimated Operating
Hours Since Last
Oil Change
Date Oil Changed
Month/Day/year
Estimated Operating
Hours Since Last
Oil Change