12
67
E
3
6
Screw bottle into water inlet on pressure
washer pump and squeeze.
I
QLWLDO
8VH
All Kärcher pumps ship with oil already inside direct
from the factory. There is no need to add oil.
3XPS
I
QVSHFWLRQ
You should routinely make a visual inspection of
the pressure washer’s pump. If you notice oil leak-
ing around the pump seals, you should take the
pressure washer to a Kärcher-Authorized Service
Center for repair. (You can locate a service cen-
ter in your area online at: www.Karcher.com.au
& www.karcher.co.nz).
3XPS
0DLQWHQDQFH
The pump on your Kärcher pressure washer does
not require maintenance. Any attempts to service
or alter the pump may damage your pressure
washer and void your product warranty.
Carry out maintenance tasks for the engine accord-
ing to the specifications provided in the operating
instructions provided by engine manufacturer.
.lUFKHU
SXPS
E
QJLQH
MAINTENANCE INSTRUCTIONS
WINTERIZING AND LONG-TERM STORAGE
CA
87
I
2
N
Failure to follow the above directions may
result in damage to the pump assembly and
accessories and void the warranty.
It is highly recommended to use Kärcher's
Pump Guard (part number 9.558-998.0) be-
fore winter storage and during the cleaning
season to protect the pump from freezing and
premature wear.
67
E
3
1
Turn engine on/off switch to the OFF position
67
E
3
2
Disconnect all hoses.
67
E
3
3
Unscrew cap from Pump Guard bottle.
67
E
3
4
Remove internal seal.
67
E
3
5
Reattach cap to Pump Guard bottle and
remove black protective cap.
67
E
3
7
With engine OFF, pull starter rope until fluid
starts to exit.
67
E
3
8
Unscrew bottle. Store or dispose properly
.
Briefly run the machine to warm it up.
Never drain the oil when engine is hot.
1. Place a suitable container near the engine to
collect used oil.
2. Remove the cap / dipstick from the oil level (1)
and drain the oil into the container, tilting the pres-
sure washer towards the oil filler tube (2).
Dispose of used engine oil in a manner that is
compatible with the environment. We suggest you
take the used oil in a sealed container to the local
recycling center or service station for recovery.
Do not throw it in the trash or pour it on the floor
or in the drain.
3. With the engine in a level position, fill up to
the high limit mark (3) on the oil dipstick with the
recommended oil (Engine manual).
Amount of filling: 0.6 L