Kärcher FC 3 Cordless, Manual

Page: 19 / 48

– 10
 Do not use the appliance for
cleaning of carpets or carpet-
ed floors.

Do not use the appliance over
the floor grilles of convector
heaters. The appliance is not
able to take in the water dis-
charged when used above
grilles.

In case of longer breaks in op-
eration and after use, switch off
the device at the main switch /
device switch and pull the
charger’s mains plug.
 Do not operate the appliance
at temperatures below 0 °C.
 Protect the unit from rain. Do
not store outside.
** FC 3 Cordless Premium
ATTENTION
Take care to ensure that the power cable lies fully in the
guide rail before fitting the handle bar.
Illustration
 Insert handle into the basic unit as far as it goes un-
til it engages audibly.
The handle must sit snugly into the appliance.
Illustration
 Place the device in the parking station for safe stor-
age.
Illustration
 Screw the cleaning rollers onto the threaded rod up
to the mechanical stop.
 Pay attention to the colour-codes on the inside of
the roller and roller holder on the appliance (e.g.
blue should match up with blue).
 After the installation, check to ensure that the
cleaning rollers sit snugly.
Illustration
 Plug the charging cable of the charger into the
charging socket on the device.
 Plug the mains plug of the charger into a power out-
let.
Illustration
 The LED indicator lights display the battery's cur-
rent charging state.
 All 3 LED indicator lights flash from bottom to top
when charging a completely empty battery.
 The lowermost LED lights up continuously when
the battery is 1/3 charged, the two upper LEDs con-
tinue to flash.
 When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED
continues to flash.
 After the battery has been fully charged, the 3 LED
indicator lights will continue to light constantly for
60 minutes. After this time, the LED indicator lights
go out.
Illustration
 Once the battery is charged, pull the mains plug out
of the socket and the charging cable out of the
charging socket.
Illustration
 Place the device in the parking station.
Illustration
 Grasp the fresh water tank by the recessed grip
and remove it from the device.
Illustration
 Open the tank cap and turn it to the side.
Illustration
 Fill the fresh water tank with cold or lukewarm tap
water.
 KÄRCHER detergents/care agents can also be
added to the fresh water tank as required.*
 Do not exceed the "MAX" marking when filling.
 Close tank lock.
Illustration
 Insert the fresh water container into the appliance.
 The fresh water tank must sit snugly into the appli-
ance.
ATTENTION
*Follow the recommended dosage instructions on the
detergent/care agent.
Description of the Appliance
1 ON/OFF switch
2 Handle
3 Wall anti-slip handle
4 Fresh water tank
5 Fresh water tank recessed grip
6 Charging socket
7 Waste water tank
8 Recessed grip cleaning roller
9 Cleaning rollers
10 Floor head cover
11 Floor head cover lock
12 Battery indicator
13 Charger with charging cable
14 Parking station
15 Roller storage
16 ** Detergent RM 534 30 ml
17 Detergent RM 536 500 ml
18 ** Detergent RM 537 500 ml
9 ** Cleaning rollers 2x
Assembly
Commissioning
Installing the rollers
Charging process
Fill fresh water reservoir
19 EN