Kärcher DS 5600 Mediclean, Manual

Page: 13 / 178

English
13
Illustration
Î
Connect connection hose.
Î
Connect the telescoping vacuum pipe to
the suction hose and attach the floor noz-
zle.
Note : Adjust the telescoping pipe match-
ing your height so that you will be able to
work comfortably while walking upright.
Illustration
Î Activate the release and extend or retract
the interior pipe to the desired length.
몇
Caution
Do not use the device if the water filter con-
tainer is empty!
When the appliance is delivered, the interme-
diate filter and the baffle plate are already in-
stalled. When filling make sure that the
components have been installed properly
(see: SCOPE OF DELIVERY). This could be
the cause of poor vacuuming performance or
untimely failure of the intermediate filter (see:
FINISH OPERATION).
Illustration
Î
Press the release button and pull out the
water filter reservoir.
Illustration
Î Remove the lid from the water filter reser-
voir and fill the water filter reservoir with
tap water until the level settles between
the MIN and MAX markings (approx. 2 l)!
Illustration
Î
Add one cap full of the defoaming liquid
(FoamStop) to the water filter reservoir.
Note : The functioning of the vacuum
cleaner is based on the whirling of the
suction air in the water filter. In the proc-
ess, sucked-in materials and deposits of
cleaning agents from floors get collected
in the water bath. This can sometimes
lead to the formation of foam. It is neces-
sary to add a capful of the foam stop liquid
to the water filter bath to avoid this situa-
tion. The foam stop liquid is environment-
friednly and fully bio-degradable. Slight
foam formation is normal and does not
hamper the functioning of the machine.
Illustration
Î
Replace the lid. Slide the water filter res-
ervoir all the way back into the appliance
and pull it up until it locks.
Note : Please refill water as soon as the
water level in the reservoir sinks below the
MIN mark.
Illustration
Î Pull the power cable all the way out of the
appliance and connect the plug to the
power socket.
Î
To switch on the appliance press the on/
off switch.
몇
Caution
Do not vacuum up large amounts of powdery
materials such as cocoa, flour, laundry deter-
gent, pudding powder or similar materials!
Illustration
Î
Use your foot to press the reversing
switch of the floor nozzle. The brush strips
at the bottom of the floor nozzle are ex-
tended.
Illustration
Î
Use your foot to press the reversing
switch of the floor nozzle. The brush strips
at the bottom of the floor nozzle are re-
tracted.
Note : If the suction power of the appliance
is constantly set too high, the suction noz-
zles can vacuum with much greater force
on carpets, upholstery and curtains. In
this case use the surrounding air separa-
tor to reduce the suction power. Close it
again after use.
Commissioning/ Operations
Connect accessories
Fill the water filter reservoir
Start working
Working with the floor nozzle
Vacuuming hard surfaces
Vacuuming carpeted floors