DG • 8.919-011.0 • Rev. 04/19
OPERATOR’S MANUAL
PRESSURE WASHER
6
23. Machines with shut-off spray gun should not be
operated with the spray gun in the off position for
extensive periods of time as this may cause dam-
age to the pump.
24. Protect discharge hose from vehicle traffic and
sharp objects. Inspect condition of high pressure
hose before using or bodily injury may result.
25. In hot water models before disconnecting dis-
charge hose from water outlet, turn burner off
and open spray gun to allow water to cool below
100° before stopping the machine. Then open the
spray gun to relieve pressure. Failure to properly
cool down or maintain the heating coil may result
in a steam explosion.
26. In oil burning models, use only kerosene, No. 1
home heating fuel, or diesel. If diesel is used, add
a soot remover to every tankful.
27. This pressure washer is equipped with pneumatic
tires which may not be fully inflated due to ship-
ping and storage. Please check the air pressure
of each tire before use:
a. Remove the valve cap from the tire.
b. Attach a bicycle pump and inflate the tire
to a maximum pressure of 25 PSI
Note: If a compressor must be used, follow the
compressor manufacturer's guidelines to limit the
output pressure so as not to exceed 25 PSI.
c. Replace the valve cap to the tire valve and
tighten firmly. Tire pressure should not exceed 25
PSI.
Follow the maintenance instructions
specified in the manual.
IMPORTANT SAFETY INFORMATION
