Kärcher BR 30/15 C, Manual

Page: 15 / 196

– 6
 Reset the suction turbine fuse on the
control panel.
 Clean the vacuum bar.
 Check, clean or replace the seal on the
dome.
 Empty the waste water tank.
 Insert the suction hose properly on the
dome.
 Check the suction hose for damages.
 Set the appliance switch to normal op-
eration.
 Fill the fresh water tank with hot water
(max. 60°C) and rinse the nozzle. Re-
place the nozzle as applicable (see
"Maintenance task/replace nozzle").
 Fill up fresh water reservoir.
 Clean the sieve in the fresh water reser-
voir.
 Set the appliance switch to normal op-
eration.
 Reset the brush drive fuse on the con-
trol panel.
 Check the drive belt, replace if required.
 Replace the worn nozzle with a new
one (see "Maintenance task/replace
nozzle").
Suction turbine does not run
Insufficient vacuum performance
No water exiting from nozzle
Brush does not turn
Carpet gets too wet
Technical specifications
Power
Nominal voltage V/Hz 220...240/
1~50/60
Type of protection IPX4
Average power con-
sumption W 1300
Suction engine output W 1130
Brush engine output W 76
Cleaning brushes
Working width mm 260
Brush diameter mm 65
Brush speed 1/min 1650
Detergent pump pres-
sure MPa 0,4
Detergent pump flow
rate I/min 1,4
Max. water tempera-
ture °C 60
Vacuuming
Cleaning power, air
quantity l/s 46
Cleaning power, nega-
tive pressure kPa 30,2
Dimensions and weights
Theoretical surface
cleaning performance m²/h 100
Fresh/waste water
tank volume l 15/17
Length mm 920
Width mm 360
Height mm 750
Typical operating
weight kg 52
Noise emission
Sound pressure level
(EN 60704-1) dB(A) 77
Machine vibrations
Vibration total value
(ISO 5349) m/s² 1,7
15 EN