12
5.906-510.0 Rev. 00 (12/10)
1 Wing nut
2 Vacuum lip
Unscrew the wing nuts.
Reverse or replace the vacuum lips.
Note
Do not transpose the front and rear vacuum lips.
Reassemble the suction bar in the reverse se-
quence.
Press the switch of the suction turbine; the vacu-
um process will start.
Lower the vacuum bar.
Push the appliance forward a bit.
Switch off suction turbine switch.
Adjustment of the vacuum bar, adjust if necessary.
1 Nut
2 Wheel
Loosen the nut.
Move the wheel upwards or downwards.
Tighten nut.
Check the setting of the vacuum bar.
1 Bowden cable
2 Screw
Loosen screws.
Remove the bowden cable.
4.7
Turn or replace vacuum lips
4.8
Check the vacuum bar setting
4.9
Setting the vacuum Bar
4.10 Dismantling / installing the brush head
