#9.800-085.0 • Rev. 6/09
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
6
STEP 1: Attach handle to the frame
of the pressure washer.
Note: It
may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 9: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle. Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8: Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 7: Connect garden hose
to the cold water source. Before
installing nozzle, turn on water
supply and run machine, allowing
water to flush through the system
until clear.
ASSEMbLy INSTRUCTIONS
STEP 6: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
frame
Assy.
Carriage
bolt
Nut
Studs
Nut
Hose/gun
Storage
bracket
Safety
Latch
Spray
gun
High
Pressure Hose
Nozzle Extension
Spray
gun/Wand
Pressure
Nozzle
Wand Coupler
Wand Collar
Pump
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
garden
Hose
Pump
Water Inlet
garden Hose
Coupler Collar
bolts