Kärcher 1.198-281.0, Manual

Page: 27 / 80

English 27
Cleaning / replacing the brush roller
Note

Replace the brush roller when it is dam-
aged.

Only dry brush roller is allowed for re-
placement.

Do not dry the brush roller using a hair
dryer.
1. Press the release button, and pull out
the brush roller.
Illustration Y
2. Remove the roller lever from the brush
roller.
Illustration Z
1
Brush roller
2
Roller lever
3. Clean up the winding hair in brush roller
and brush lever.
4. Install the roller lever, and i nsert dry or
new brush roller into floor nozzle, and
fix the brush roller into place.
Illustration AA
Ensure that the brush roller fits properly.
Troubleshooting guide
Malfunctions often have simple causes that you can remedy yourself using the following
overview. When in doubt, or in the case of malfunctions not mentioned here, please contact
your authorised Customer Service.
Warranty
The warranty conditions issued by our relevant sales company apply in all countries. We
shall remedy possible malfunctions on your appliance within the warranty period free of
cost, provided that a material or manufacturing defect is the cause. In a warranty case,
please contact your dealer (with the purchase receipt) or the next authorised customer ser-
vice site.
(See overleaf for the address)
Fault Possible cause Remedy
The appliance does
not run.
Filter set / dust container is
missing.
1. Install the filter set and the dust
container before using the appli-
ance.
Battery is nearly empty. 1. Charge the battery.
The appliance is in danger of
overheating.
1. Check whether the dust contain-
er is clogged.
2. Clean the dust container.
3. Switch the appliance on again.
Suction capacity
decreases. / Abnor-
mal sound or oper-
ating noise which
becomes louder.
Dust container is full.
HEPA filter set is clogged.
1. Check the dust container.
2. Empty / clean the dust container
and the HEPA filter set.
3. Check and clean the cyclone set.
The floor nozzle is
shut down auto-
matically.
It is in danger of overheating. 1.Check whether the brush roller is
blocked, and clean the brush roller.
2. Switch on the appliance again.