![background image](http://html1.mh-extra.com/html/karcher/1-109-151-0/1-109-151-0_manual_4207673011.webp)
Operating Manual HDS Standard 9.808-214.0
11
PRESSURE W
ASHER
OPERA
TOR’S MANUAL
ASSEMBLY & INSTALLATION INSTRUCTIONS
READ OPERATOR’S
MANUAL THOROUGHLY
PRIOR TO USE.
CAUTION
CAUTION
Water Connection
The water source for the pressure washer should be
supplied by a minimum 3/4" I.D. garden hose with a city
water pressure of not less than 30 PSI.
Flow rate of water supply must not fall below 5 GPM.
The water supply temperature must not exceed 105°F/40°C
Never use the pressure washer to draw in water
contaminated with solvents, e.g. paint thinners, gasoline,
oil, etc.
Always prevent debris from being drawn into the unit by
using a clean water source. Use additional water filter.
Pump And Coil Protectant (RM110)
The pump and coil protectant RM110 prevents the
calcification on the heating coil while operating with
calciferous tap water. It is dosed into the supply in the float
container drop by drop. (except HDS 2.2/12 Ed)
The metering is set to medium water rigidity by the
manufacturer.
• Refill system care via the RM110 tank container.
Note:
Order in case of 12 bottles, using part # 8.698-058.0.
STARTING AND OPERATING
INSTRUCTIONS
To Start:
1.
STOP!
Read operator's manual
before operating. Failure to
read operation and warning
instructions may result in per-
sonal injury or property dam-
age.
2. Connect water supply hose and
turn on water.
3. Check fuel tank and pump oil
levels.
4. Connect high pressure hose to discharge outlet.
Securely attach spray gun, lance and high pressure
nozzle
5. Connect the power cord into the proper electrical
outlet. Only for single-phase models: push the GFCI
reset button (Refer to serial plate for information).
6. Hold gun firmly, squeeze trigger of spray gun and turn
appliance ON. Allow air to purge from system.
7. Set appliance switch to desired operating mode.
Indicator lamp for operational readiness lights up.
The device starts briefly and turns off, as soon as the
working pressure is reached.
Release the trigger gun. To do so, push the safety catch
towards the back.
When activating the hand spray gun the device switches
back on.
Adjust Cleaning Temperatur
e
Set temperature regulator to desired temperature.
86 °F/30 °C to 194 °F/90 °C
•
Clean with hot water.
Set Working Pressure And Flow
Pressure/quantity regulation of the pump
(not HDS 2.2/12 Ed)
Turn the regulation spindle in a clockwise direction:
Increase working pressure (MAX).
Turn the regulation spindle in an anti-clockwise direction:
Reduce working pressure (MIN).
Operation With Detergent
For considerate treatment of the environment use
detergent economically.
The detergent must be suitable for the surface to
be cleaned.
With support of the detergent dose valve set detergent
concentration as determined by the manufacturer.
Cleaning
Set pressure/temperature and detergent concentration
according to the surface to be cleaned.
Note:
To prevent damage due to too much pressure,
always position high pressure ray first
Recommended cleaning method
Loosen the dirt:
• Spray detergent economically and let it work for
1...5 minutes but do not let it dry up.