Safety Information
Page 18 of 20
11. Maintenance of Mobile Phone
Mobile phone is a high-precision electronic product, so please take good care of it. The following
suggestions can help you preserve it and lengthen its useful life:
Put mobile phone and its accessories to the place where children are out of reach.
Keep mobile phone dry. Rain, moisture or water may erode circuit board. If mobile phone
falls into water carelessly, take battery out in time and send it to local authorized service
center immediately.
Please do not put mobile phone at dust-covered place or its normal usage will be affected.
Liquid
crystal
display is an easily vulnerable part of mobile phone, try to prevent it from
falling down or violently shaken; it is forbidden to use sharp item to touch the screen.
Please do not put mobile phone on the place where temperature is too high. High
temperature will shorten the life of electric equipment, damage the battery, deform or melt
its plastic cover.
Please do not put mobile phone on the place where temperature is too low, or moisture will
come out when its temperature increases to normal temperature, it will damage the circuit
board
of mobile phone.
Please do not throw, knock or forcefully shake mobile phone to avoid its inner circuit
board
and precise structure are damaged.
Please do not clean mobile or with chemical agent, cleaning solvent or powerful detergent,
instead, clean it lightly with soft cloth with soap water.
Please do not draw mobile phone with painting material to prevent its removable parts from
being stuck, which will affect its normal operation.
Please use cleaning soft cloth to clean lens, such as camera’s lens.
When antenna is replaced, use only supporting or designated antenna. Using unauthorized
antenna, accessories or reshaping mobile phone may damage it or violated relevant wireless
electric equipments.
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
