MICRO REMOTE
5
at this point. Release the
POWER button.
3.
Apply power to the receiver
4.
Only the green LED should
start to blink rapidly on the
transmitter
5.
Teach complete
CLONING
Warning! This feature can
pose a safety hazard for
operators
if
both
transmitters
are
used
simultaneously! Use with
caution!
Occasionally, it is
desirable to have more than one
transmitter work with a single
receiver. This is accomplished
by a process called cloning.
Cloning allows an additional
transmitter (B) to have the
same ID code as the original
transmitter (A). If this feature is
desired,
use
the
following
procedure:
1.
Make sure transmitters
and receivers are off
2.
On transmitter A, press and
hold POWER button for
more than 10 seconds.
LEDs should blink at this
point. Release POWER
button
3.
On transmitter B, press and
hold buttons ROLL RIGHT,
ROLL LEFT, and POWER
until the LEDs start to
blink. Release buttons
4.
Wait for a few seconds until
the green LED only starts
to blink on transmitter A
and transmitter B turns off.
5.
Turn off both transmitters
6.
Synchronize one of the
transmitters
to
the
receivers
If cloning feature has been
invoked and is no longer
desired, the ID code of one of
the transmitters needs to be
