W
ArNINg
I
NvEsTIgATE
ThE
lAyOUT
Of
yOUr
AUTOmOBIlE
ThOrOUghly
BEfOrE
drIllINg
Or
CUTTINg
ANy
hOlEs
. U
sE
ExTrEmE
CArE
WhEN
yOU
WOrK
NEAr
ThE
gAs
TANKs
,
gAs
Or
hydrAUlIC
lINEs
,
ANd
ElECTrICAl
WIrINg
. A
lWAys
mAKE
sUrE
ThE
A
mplIfIEr
Is
sECUrEly
mOUNTEd
.
m
OUNTINg
ThE
A
mplIfIEr
sECUrEly
TO
ThE
AUTOmOBIlE
WIll
prEvENT
dAmAgE
TO
ThE
CAr
Or
INjUry
TO
A
pErsON
,
pArTICUlArly
IN
ThE
EvENT
Of
AN
ACCIdENT
.
PRE- INSTALLATION
Before making or breaking power connections in your system, disconnect
the vehicle battery. Confirm that your source unit or other equipment is
turned off while connecting the input jacks and speaker terminals.
Use only proper car audio insulated 4ga. (or larger) power cable. The
+12Volt power cable must be connected with a in-line fuse within 8in
from the positive battery terminal.
If you need to replace the power fuse, replace it only with a fuse identical to
that suggested by this manual. Using a fuse of a different type or rating may
result in damage to your audio system or your amplifier which is not covered
by warranty.
Use only car audio RCA cables, otherwise you may get sound distortion.
Keep these cables as short as possible. To avoid distortion from your car
electronics, avoid installing the RCA cable close to any existing cables and
other electric devices.
Take care when pulling wires through the vehicle to avoid any damage to
the cable or it’s insulation. Special care must be taken when installing the
cable through metal openings as any crack or split in the cable insulation
may cause an electrical short. Don’t install cables too tight
The amplifier must be mounted securely at a solid, dry and low vibration
surface in the trunk or passenger area. Fix the amplifier in an open air area
to insure proper heat dissipation. Fix the amplifier in a place where the
amplifier can access easily to set input controllers.
The ground cable should be connected directly with the chassis of your
vehicle which should be metal to metal ground point connection.
- 2 -
Mono Block Amplifiers
