NOTE:
Learning mode lasts for 12 seconds; if no signal is given to the receiver then it will automatically exit learning
mode without pairing the device.
To exit learning mode manually, simply press the
‘Learn’
button again.
！
If, during learning mode the load does not flash to confirm, this means that the receiver’s memory is
FULL
and no
further remote control may be paired unless one of the existing remote control is first unpaired (see below).
Un-pairing
Removing single Device:
1.
With the receiver that you intent to un-pair press the
‘Learn’
button once (LED will flash), this will now enter learning
mode.
2.
On the wall switch press the
‘OFF’
button; the load will flash twice to confirm that the wall switch is now unpaired.
Product Setup
Manual ‘ON/OFF’ function.
With a screw driver position the rotary dialer to ‘0’ position.
Delay ‘Off’ function.
5secs (more suitable for gate door) / 30secs / 5mins / 10mins / 30mins / 1hr / 3hrs
With a screw driver adjust the rotary dialer to the desired time.
Example: Set at ‘3hr’
