8
KSTB2020
User Guide
STB / Remote IR – RF Mode Conversion
For customers who wish to place the STB in a non-line
of sight position (with respect to the remote control) the
remote must operate in RF mode. As the remote operates
in IR mode by default the user will have to convert the
remote operation from IR mode to RF mode.
While the STB and TV are turned on and operational the
remote may be converted from IR mode to RF mode by
the following sequence.
•
While pointing the remote at the STB front face
plate press and hold the set key for approximately 3
seconds. The remote LED will display red.
•
After 3 seconds the remote LED will turn green.
Immediately press the home button.
•
A 3-digit code will be displayed on the TV screen.
•
While pointing the remote at the TV, enter the 3-digit
code shown on the TV.
•
If successful, “Connected” will be displayed on the
TV screen and the remote now operates via RF mode.
If “Connected” is not displayed, wait 3 minutes, then try
the above procedure again.
Once successfully paired (connected), the STB may be
placed in a non-line of sight location.
To return the remote to the line of sight IR mode of
operation perform the following steps:
•
On the remote press and hold for 3 seconds,
until the LED turns green
•
On the remote Press
•
Successful completion is signaled by 2 green blinks
8
9
1
Battery
Installation
The remote
requires two
AA batteries.
The remote
can be opened
by holding the
thicker side of
remote in your
right hand and
sliding the
top (button)
section to
the left while
sliding the
lower section
to the right.
Remote Pairing Operation
REMOTE CONTROL FUNCTIONALITY
Set
