8
Auto Power-up (APU) / Auto Power-down (APD)
The YU is designed to save power when not in use. When no audio signal has been
detected for 15 minutes, the YU Amp will put itself into stand-by mode (APD). If the
audio signal returns via the same input that the YU was playing when it entered standby,
the YU will wake up and resume playing (APU). It can also be woken up manually by:
• Pressing the Standby Button on the Remote
• Pressing the Control knob on the speaker
If you do not find the APU feature useful, you can disable it by pressing the Balance
Reset button on the remote and holding it for 5 seconds. The Status LED will blink
once to indicate that you have disabled the APU feature. To enable the APU if you have
disabled it, simply press and hold the Balance Reset button again for 5 seconds. The
Status LED will blink twice to indicate that you have enabled the APU.
If you do not find the APD feature useful, you can disable it by pressing the Bass Reset
button on the remote and holding it for 5 seconds. The Input LED will blink once to
indicate that you have disabled the APD feature. To enable APD if you have disabled it,
simply press and hold the Bass Reset button again for 5 seconds. The Input LED will blink
twice to indicate that you have enabled APD.
These settings will revert to factory defaults if the power switch is turned off or the unit
is unplugged.
