4
A: LINE IN RCA - Input jacks, accept up to 1.4 volts of audio input signal (mono and stereo)
B: LINE OUT RCA - High pass filtered RCA output jacks with left and right line output signals. The line out RCA’s
are not functional when the line in signal (going into the subwoofer) is derived from a sub-filtered output of an
external processor.
C: CROSSOVER - The 12dB/Octave variable crossover filter is designed to control the subwoof cut off frequency
(Range from 40 hz to 180Hz)
D: VOLUME - Manual adjustment of the sound level of the subwoofer. Always start at MIN position add slowly
increase the volume to reach the desired subwoofer level.
E: PHASE SHIFT - 0 - 180 degrees subwoofer phase shift switch
F: POWER SWITCH - For operating the amplifier automatic or manual power on. In automatic mode, the YARO
subwoofer will turn OFF after 15 minutes if no audio signal is detected.
G: POWER INPUT - The YARO subwoofer operates in 115V and 230V environments. A sliding switch located
near the power plug allows for both operations.
H: AC POWER - Power plug
I: MASTER POWER - Switch off to converse power when product is not used for long periods.
J: SUB IN -
Secure all connections before turning on YAROsub.
Connect the input signal into either the RCA line in (A) or Sub in (J)
In case the YAROsub becomes out of phase with the satellite speaker, flip the phase switch to correct the
problem. Maximum bass can only be achieved when the sub is in phase with the rest of the speakers.
Consult page 6 for fine tuning and positioning of your subwoofer.
Connections and Controls
Operation
