Figure 2. Activating stand-alone mode.
Other ways to activate Stand-alone mode
Alternatively you can select the
Other ways to activate
button.
1. Contact Kantech Technical Support in your region to get an
Activation
code
.
2. Enter the
Activation code
.
Figure 3. Other ways to activate stand-alone mode.
Using EntraPass mode
To use in
EntraPass
mode click the
EntraPass
button.
1. Navigate to the
EntraPass gateway
pane.
2. Enter the
IP address
or
Domain name
.
3. Select a
Protocol
(TCP or UDP).
4. Enter a
Port
(UDP only).
5. Click the
Save
button.
Setting up using the wizard
The wizard will help you set up the KT1 in just a few steps.
Entering credentials
l
Enter your credentials selecting
Installer
or
Operator
and
click
Next step.
Notes:
1. In the password field, the minimum password requirements
are 8 characters including lowercase, uppercase, a number
and a special character.
2. There is no way to restore a forgotten password. You must
factory reset the unit.
Setting the date and time
l
Configure the
Date
,
Date format
,
Hour
and
Time zone
, and
click
Next step.
Formatting cards
1. Select your card's
Reader Type
and card format where
HHHH:DDDDD
is the default.
2. Choose the
Number of PIN digits
.
3. To
Allow PIN duplication
check the box and click
Next step
.
Configuring doors
1. Define the
Door name
and enter the corresponding reader
Serial number
(ioSmart only).
2. Enter the corresponding reader
Serial number
for the
Exit
door (ioSmart only).
3. Choose from
Fail safe
or
Fail secure
, and click
Next Step
.
4. In the
Summary & Backup
tab, review the information
entered and select
Save
.
Note:
The
Door Contact input
and
REX input
boxes are checked by
default.
Need help?
Please refer to the installation guide for technical support contact details.
For further information, go to our support section at
www.kantech.com
© 2017 Tyco Security Products. All Rights Reserved.
