I n s t a l l i n g a n d W i r i n g I o P a s s ™
- Mounting the IoProx P100 Reader
10
2.6
Mounting the IoProx P100 Reader
NOTE:
For model SA-600 only.
To mount the IoProx proximity reader, please refer to
installation instructions provided with the reader.
NOTE:
If the IoPass unit and P100 reader are not on the
same side of the door, you will not be able to use the “card
and PIN” mode since the keypad of the IoPass unit will not
be accessible to cardholders when a valid card is presented
to the P100 reader.
Wiring Diagram
2.7
Connecting the Door Locking Device
To install the door locking device, refer to the
manufacturer’s instructions. To connect it, refer to the
diagram below.
Wiring Diagram
2.8
Connecting the T.Rex Exit Detector or Exit
Button
To install the T.Rex Exit Detector/push button, refer to the
manufacturer’s instructions. To connect it, refer to the
diagram below.
Wiring Diagram
2.9
Connecting the Door Contact
To install the door contact, refer to the manufacturer’s
instructions. To connect it, refer to the diagram below.
Wiring Diagram
2.10
Connecting the Alarm Annunciator
To install the alarm annunciator, refer to the
manufacturer’s instructions. To connect the annunciator
(i.e.: horn, bell, etc.), refer to the diagram below.
Wiring Diagram
Summary of Contents for IoPass SA-500
