INSTRUCTION MANUAL
Please keep this manual for future reference.
PRESSURE SWITCH WITH CHANGEOVER SWITCH
TYPE 602/652
Maybachstraße 18
72175 Dornhan
Tel +4974559461-0
Fax +4974559461-13
Email: [email protected]
The following warnings and instructions are to be observed at all times.
SECURITY
These installation and operating instructions are intended both for fitters and maintenance personnel as well as for design engineers who require
the pressure switch for an application. Please read the entire instruction manual carefully before commissioning and pay particular attention to the
alerts and notes explained below.
Safety instructions
Instructions for the safe use of the pressure switch:
•
Do not exceed any of the stated limit values.
•
Remove all packaging before installation.
•
Extreme environmental influences such as high temperatures, humidity, dirt etc. must be avoided at all costs. These can lead to failure of the
pressure switch.
•
Do not use any damaged installation elements and always ensure good fastening.
•
Always make sure that all fixing screws are in place and connected tightly.
•
The pressure switch must not be exposed to strong vibrations.
•
The user must check whether the plug connection complies with the regulations for the stated degree of protection.
•
Switch off the pressure medium during assembly or repair work on the pressure switch.
•
Piston pressure switches are not suitable for gaseous media (oxygen, etc.). All safety regulations must be observed when using oxygen with
diaphragm pressure switches.
•
The overpressure safety refers to static load. With dynamic load, the value is reduced by at least 25%.
•
Always observe the safety and warning instructions during installation and commissioning.
Note: This document is available for download on our homepage www.Kant-Druckschalter.de .
Only the documents currently obtained via our homepage are valid.
Caution: Failure to observe can lead to injuries.
602 with device
connector 600
602 with non-detachable
device connector 601
