219 Route 206 Phone: 1-800-247-8887
PO Box 372
Fax: (973) 786-7586
Andover, NJ 07821 USA [email protected]
6813
™
User Manual, PN 10283
Kanomax USA, Inc
Rev 2.0, 24-Nov-2009
www.kanomax-usa.com
Copyright © 2008, Kanomax USA, Inc.
Page 8 of 24
TM
Press the TEMPERATURE key to display the current temperature of
the air stream as measured by the Air Probe. To switch the units
between degrees Fahrenheit (°F) and degrees Celsius (°C), press
the TEMPERATURE key again. Either
°C
or
°F
will be displayed along with
the reading.
Press the FPM/MPS key to display the current air velocity as measured
by the air probe. To switch the measurement units from FPM (feet per
minute, 1 FPM resolution) to MPS (meters per second, 0.01 MPS
resolution), press the FPM/MPS key again. Either
FPM
or
MPS
will be
displayed along with the reading.
Press the SAMPLE RATE key to change the measurement averaging
rate (“sample rate”) of the instrument
for air velocity only.
2SEC
An average value of airspeed measurements during the
preceding 2 seconds is displayed.
4SEC
An average value of airspeed measurements during the
preceding 4 seconds is displayed.
8SEC
An average value of airspeed measurements during the
preceding 8 seconds is displayed.
16 S
An average value of airspeed measurements during the
preceding 16 seconds is displayed.
Note:
The sample rate for
temperature
readings is
always 2 seconds.
219 Route 206 Phone: 1-800-247-8887
PO Box 372
Fax: (973) 786-7586
Andover, NJ 07821 USA [email protected]
6813
™
User Manual, PN 10283
Kanomax USA, Inc
Rev 2.0, 24-Nov-2009
www.kanomax-usa.com
Copyright © 2008, Kanomax USA, Inc.
Page 17 of 24
TM
APPENDIX G – VIEWING AND CAPTURING DATA
(IF EQUIPPED WITH EITHER USB OR RS232 OUTPUTS)
There are many ways to capture the serial port data from the Kanomax
Instrument. The simplest method is to use a terminal emulator program.
Using a terminal emulator allows the serial COM port to be opened, with
the above port settings, and real-time data to be viewed from the
instrument. One such terminal emulator program is Windows
HyperTerminal.
To launch Windows HyperTerminal, go to:
START
→
All Programs
→
Accessories
→
Communications
→
HyperTerminal
Enter a name for the Connection, such as “Kanomax 6812” and choose
an icon.
Click OK.
