KANG Industrial VS-300, Operating Manual

Page: 11 / 26

11
blade through. Weld the blade ends together (grinding smooth). Reinstall blade on
wheels and make normal blade adjustment. Begin to perform contour sawing.
5. Working Speed: When sawing, the speed shall remain the same (neither fast nor
slow); otherwise, blade breaking may occur.
M. Safety and Maintenance:
1. Be sure that the safety cover and the wheel doors are always closed before turning
on the machine.
2. The band saw shall be installed in a dry place in order to avoid electrical shock.
3. Make sure the machine is grounded properly (green wire to ground).
4. After installing a new saw blade, start the motor and keep the blade turning without
load about 1 minute; then proceed to cutting the work piece
5. Upon sawing, if any unusual noise, smell or blade breakage occurs, operator should
immediately switch off the power.
6. Maintenance: After operating, switch the machine off. After clearing the machine,
take away the chips, and slightly lubricate the surface of the machine and all joints
to keep them from rusting.
VI.INVERTER PARAMETER:
1
．
Consumers are not allowed to adjust the parameters without authorization .(In case that
machine failure is caused by any consumer who alters any parameter without authorization,
the consumer should be responsible for the failure.)
2.Inverter parameters are only provided for the qualified technician.
MAINTENANCE AND CAUTIONS
Remarks:
1.
This welding device isn’t recommended to weld saw blades made of high speed steel.