15
16. RECOMMENDED OILS
Motor oil significantly affects the engine performance and is the main factor that
determines its service life. Use oil intended for four-stroke automobile engines,
as it contains detergent additives that meet or exceed the SE standards according
to the APE classification (or equivalent). Generally, it is recommended to use oil
with a viscosity of SAE 10W-30. Motor oils with a different grade shown in the
table can be used only if the average air temperature in your area does not fall
outside the specified temperature range. SAE oil viscosity or oil service category
is indicated on the APE tank label.
REPLACING OR ADDING MOTOR OIL
If the oil level drops, fresh oil must be added to ensure proper operation of the
generator. Check the oil level according to the maintenance schedule.
To drain oil, proceed as follows:
1. Wear protective gloves to avoid getting oil on your skin.
2. Place an oil drain tray under the engine.
3. Unscrew the drain cap located on the engine under the dipstick cap with a
10 mm wrench (for generators up to 3.0 kW) or 12 mm (for generators above
3.0 kW).
4. Wait for the oil to drain.
5. Replace the drain cap and tighten securely.
6. It is better to drain oil while the engine is still hot after operation to ensure
quick and complete oil draining.
To add oil, proceed as follows:
1. Wear protective gloves to avoid getting oil on your skin.
2. Make sure the generator is mounted on a flat, level surface.
3. Unscrew the dipstick cap on the engine.
4. Use a funnel to fill the crankcase with high-grade oil. The funnel is not
included. After filling, the oil level should be close to the top of the oil filler.
-20
-10
0
10
20
30
40
0
C
5W-30, 10W-30
Fig. 10
Drain cap
Dipstick cap
Fill to here
Summary of Contents for KS 2200A
Page 22: ......
