INSTALLATION INSTRUCTIONS
Continued
7. Release the 2 clips which reatins the airbox lid
then remove the lid from the vehicle.
8. Remove the three nuts that retain the airbox
bottom to vehicle.
9. Remove airbox bottom from vehicle as shown.
NOTE: K&N Engineering, Inc., recommends
that customers do not discard factory air
intake.
10. Remove the 8mm bolt that retains the radiator
fan shroud to radiator.
11. Install the provided bracket (07879) onto
radiator with the provided hardware.
12. Install the two provided brackets onto the
factory rubber mounted studs with the provided
hardware.
Note: Install bracket (07093) onto the lower
rubber mounted stud.
13. Install edge trim onto heat shield as shown.
Trim if needed.
14. Install the heat shield into vehicle and attach to
the two outter brackets.
15. Using the provided hardware, assemble the
saddle bracket assembly as shown.
16. Install the saddle bracket assembly onto the
heat shield as shown.
17. On vehicles that come with external temp
sensor drill out the drill point with a 3/4 drill, then
install the provided grommet as shown.
18. Install the provided silicone hump hose
(087121) onto the K&N
®
intake tube with the
provided hose clamps.
19. Install the K&N
®
intake onto the throttle body
and line it up with saddle bracket assembly.
Note: Do not tighten completely.
20. Remove the four bolts that retain the mass air
sensor to the airbox lid, then remove the mass air
sensor from lid.
21. On vehicles that come equipped with an
external temp sensor, twist counter clockwise to
remove from airbox lid.
22. Assemble the filter adaptor onto the mass air
sensor with the provided hardware as shown.
23. Install the silicone hose (08690) onto the mass
air sensor with provided hose clamps as shown.