Assembly
To assemble the speaker wall mount, proceed as follows :
1.) Unpack and check item for damage and completeness
Technical data
Material
Wall mounting plate, swivel joint, base tube, adjustment tube, stake-out plate
and mounting bolt: steel, powder-coated black
Screw, washer and nut: steel, galvanised
Protective caps and square hole washer: plastic, (PE, PA)
Load capacity
25 kg
Dimensions
and adjustment
range
Mounting bolt: ø 35 x 84 mm
Wall plate: 220 x 120 x 5 mm
W x D x H: 120 x 499 x 277 mm, base tube horizontal
W x D x H:
120 x 445 x 470 mm, base tube -30°
Angle of inclination: 0° bis -30° in six settings
Swivel: 140°
Wall-to-bolt clearance: 172 mm, 202 mm, 232 mm, 262 mm
Packing
497 x 363 x 217 mm
Weight
4.0 kg
Mount the mounting bolt.
The speaker wall mount is pre-assembled.
You only need to tighten the mounting bolt or set the correct
position beforehand.
Select one of the four holes for positioning and screw the bolt
with suitable tools as follows.
Insert the cylinder head screw through the mounting bolt.
From below, screw the nut by using the washer and put on the
protective cap. Disassembly in reverse order.
2.) Assembly of speaker wall mount
All six holes of the wall mounting plate must be used. A
suitable fastening material must be selected according to
the respective wall texture.
The info sheet "General safety and assembly instructions"
must be observed.
Align the speaker wall mount on the wall and mark the six
mounting holes on it. Drill holes according to the selected
fastening material. Follow the manufacturer's installation
instructions. Attach the speaker wall mount to the wall and
screw it tight.