KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18816-000-55 Rev.06 03-80-157-00 12/12
TECHNICAL DATA / SPECIFICATIONS
NOTES FOR USE
The tilt and viewing format of this iPad Holder can be
adjusted.
And the keyboards are easy to adjust.
WE RECOMMEND:
a. When adjusting the height, e.g. for transporting the
a.
stand, removing the iPad from the cradle, as jolting
a.
may be unavoidable.
b. When changing the viewing format or tilt, we suggest
b.
leaving the iPad in the cradle – but nonetheless
b.
moving it with care.
10
HEIGHT
10
Hold the stand rod firmly, remove the clamping
10
screw from the cross bar completely, select a bore
10
hole on the stand rod and re-attach to the cross rod
10
using the clamping screw.
11
TILT
11
Loosen side wing nut
7
and set the tilt of the cradle.
11
Re-tighten the nut.
12
FORMAT
12
The cradle can be turned 90° so that the iPad is
12
presented either vertically or horizontally.
12
Stop mechanisms prevent slipping.
12
TIP: Place the on button under
12.a
or right
12.b
12 Tip:
so the pull of the cable works against the stop
12 Tip:
mechanism.
INSTALLATION
of the iPad cradle
7
tighten wing nuts
8
slot in the iPad at the lower edge and
9
clip in at the top
MAINTENANCE, CLEANING
- Remove the iPad before starting maintenance and be
-
aware of potential hazards
- For cleaning purposes utilise a slightly damp cloth with a
-
non-abrasive cleaning solvent
FAULT FINDING (FF) & SOLUTION (S)
FF: The holder wobbles
FF:
S: Cross bar is not attached to the stand section
FF: S:
firmly
FF:
S: Cross bar and adapter/keyboard stand are not
FF: S:
connected firmly
FF:
S: Adapter is not screwed tightly to the keyboard stand
FF: Cradle wobbles
FF:
S: Tighten wing nuts
FF: SEAT of the iPad in the holder
FF:
S: Gently bend the adapter plate into position
13
FF:
S: NOTE! Not suitable for iPad 1. Generation
18816 iPad Holder
Material
grips, cradle: PA, black
stand rod, cross rod: steel
max. load
iPad 2. Generation (630 g), iPad 3. Generation (670 g)
Size
cradle: 252.1 x 104.8 x 195.4 mm
Card
385 x 265 x 145 mm
Weight
net: 1.2 kg, gross: 1.6 kg
TILT
HEIGHT
INSTALLATION
FORMAT
TIPP
SEAT
connection for headphones
connection for
headphones
Home-Button bottom
if the iPad is
too loose
attach the iPad again,
test it and bend it again
if required
remove iPad and bend
the holder gently but
firmly inside
Home-Button
right