7.
LOOP BYPASS SWITCH
-
The EFFECTS LOOP can be bypassed by placing the
LOOP BY
P
ASS SWITCH in the "UP" position. The overall gain of the amp will
be significantly reduced, and the effects level control becomes a reverb
drive control.
8.
EFFECTS SEND
-
Use this jack to send the amplifiers signal to
outboard effects.
9.
EFFECTS RETURN
-
Use this jack to connect the output of your
effects to the amplifier.
10.
EFFECTS LEVEL
-
Adjusts the return signal level. It also acts as a master
volume control. Do not set fully counterclockwise, as this will shut off signal
to the output section, resulting in no output level. Normally this control
should be set at the 12 o’clock position.
11.
LEAD EQ
-
The TREBLE, MIDDLE, and BASS controls on the rear panel affect
only the LEAD CHANNEL.
NOTE: Both the “Lead” and “Bypass” front panel switches must be
in the “down” position to enable footswitch function.
Page 5
