•
Attach washer and strap mount knob and tighten it. The flat head screwdriver slots on the jack end allow
holding it tight with a screwdriver or a knife.
Endblock thickness
adjustment nut
•
Note:
Make sure that the strap knob screws in ALL THE WAY over the outer threaded part of the jack, so
that a tiny portion of the thread is exposed when the strap-knob is tightened.
###
Removal of Pickups
(please read and understand the disclaimer below)
:
Double-sided Tape Installation:
•
Please do not pull the pickups off by the wire!
•
Use an
old, dull
razorblade to loosen the pickups.
Please be very careful
when handling the razor
blade
. If you don’t have a dull one, scrape the blade of a new one over some sandpaper.
•
Carefully remove the duct tape over the pickup cables.
•
Slide the dull razor blade
under
the pickup on the cable entry side. Make sure the blade gets
in between
the pickup and the wood. Avoid to accidentally cut the pickup apart. Be very careful not to bend the
pickups. Keep the blade almost parallel to the guitar top.
•
This removal procedure requires some skill ! If you do not feel up to this task please contact a luthier or
your music stores guitar-tech.
There will be some glue residue on the base plates of the pickups.
You can clean it by rubbing it off with your thumb. If you like to use a solvent, “Naphta” is working best. Please
check at your hardware store.
After the pickups are cleaned, plug them into your amp and tap on the golden surface of each pickup with a finger
to make sure that all pickups work.
The tapping sound should be clearly amplified. All pickups should perform with the same sensitivity and loudness
level. Now the pickups are ready for re-installation.
Superglue Installation:
If the pickups were glued directly to the bridgeplate removal is not recommended.
However, experienced luthiers should be able to remove the pickups by using a razor blade. Be aware that this
will very likely damage the piezo transducers.
It also is dangerous to work with a razor blade inside your guitar where you can’t see what you are doing.
###
Please make sure you read, understand and agree to the disclaimer below before you proceed with the
installation. Please call our help line if you have any questions: (541) 888-3517
If you have doubts please do not install this product.
DISCLAIMER regarding the installation or removal of the Pure Western, Pure Classic, Mini Pure and any
product which contains any of these transducers:
Installation or removal of the above listed products is at your own risk. In no event will K & K Sound Systems Inc.
be liable to you for any damages arising from your use of, or, the inability to use these products. This includes any
possible health hazards, accidents, injuries, any lost profits, or other incidental or consequential damages, even if
K & K Sound Systems Inc. has been advised of the possibility of such damages, or for any claim by another party.
Exact following of mounting instructions and handling instructions for supplied superglue is mandatory.
7
Summary of Contents for pure classic
Page 8: ...8 ...
