2
JACK INSTALLATION
Clamp the jack with its mounting plate between the
A and D string behind the bridge (see illustration,
right).
PREAMP ADJUSTMENT AND FINAL SETUP
Install a 9-volt battery in your preamp in the
designated space. Remove the snap-off lid. There is
no need to undo any screws to remove the lid, it
simply snaps off.
Important: Please do not tamper
with the screw on the bottom of the preamp!
There is a diagram on the inside of the lid with the
internal tone and gain controls. In the box you will
find a little screwdriver for the adjustment of the
trimpots. Connect the supplied stereo cable from the
pickup into the preamp input. Plug the preamp into
your amplification system at a linear setting.
Now adjust the gain with the trimpot of each
individual channel until both pickups are equally
loud. Adjust the bass and treble trimpots to your
preference. Close the box and you are ready to go.
Unplug the output cable at the mixer after usage to
shut off battery!
Channel 1: Wing Transducer
Channel 2: Quad/Bridge Transducer
TECHNICAL DATA
Four-Head Transducer: 3/4" Head Diameter
Wing: 22 mm Diameter / Thickness 5 mm
Preamp Dimensions: 3" x 3.5" x 1"
Input Impedance: 1 MegOhm
Output Impedance: 10 KOhm
Input: Stereo
¼
”
Output:
¼
”
Power: 9-volt battery
Supplied with Stereo Connection Cable
All K&K products are designed, assembled and
packaged in USA using mainly US and European
components. Thanks again for choosing K&K.