16
CONTROL PANEL LAYOUT
Switching the hob On/Off
To switch the hob on, press the
button and the cooking zone displays light up. To switch off,
press the same button until the displays switch off.
If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled
down.
If within 120 seconds of switching on, no heating zone is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Once the hob is switched on and the pan is positioned on the cooking zone, the display shows
level 0.Each cooking zone has various power levels, adjustable with the
buttons, going from “1”: min. level, to “9-P”: max. level.
Specifically function
Select the cooking zone you wish, and press the same number level button twice; the point
corresponding display shows. The cooking zone will work high level. Push the number level again,
and then the cooking zone will recover to previous level.
Power Booster function
Push this button two times, the unit will go into Power boost function and
will working in 2400W. After five minutes the power will back to original power level.
Deactivation of cooking zones
Press the key “
” to set the level to “0”. The cooking zone switches off and the residual heat indicator “H”
lights up.
Child lock
This function locks the controls to prevent accidental switching on of the hob. To activate the
child lock function, switch on the hob and hold button
for three seconds; the timer shows Lo.
Then the control panel is locked.
To deactivate the control panel lock, repeat the activation procedure. The Lo goes off and the hob is active
again.
Timer
The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes)
press the button with the
clock symbol
then set the desired cooking time using the
buttons of the
timer function (see figure). After a few seconds, the timer begins the countdown. Once the set time has
elapsed, an acoustic signal sounds and the hob switches off automatically.
To deactivate the timer, press the “
” button to set the display showing “00” or hold the button with the
clock symbol for at least 4 seconds.