Operating Instructions
K&F SONA SUB II
KLING & FREITAG GMBH © 2016
Version 1.5
Page 15 of 21
•
Switch on the mixing console first, then the controller and the power amplifier. Always
use the before mentioned switching order. Otherwise switching noises may damage the
sound system.
•
If there is interference, turn off all appliances in the reverse order and check all cable
connections.
•
Successively turn up the individual power amplifier channels and send a signal with low
volume to the system. Check whether the audio is properly routed to the appropriate
speakers. Make sure no noise is heard through those speakers.
•
Turning down the input level controls may not always prevent distortions in the input
section of the power amplifier, especially if this section has a relatively low headroom.
A clipping signal may not be displayed by the clipping indicator then! To prevent signal
interruptions or damages to the speakers, turn the level controls of the power amplifier
to the maximum position, if possible. Set the output level of the mixing console or the
controller to a level that doesn't overload the power amplifiers or decrease the limiter
threshold of the controller.
•
When turning off the system, the input controls for the power amplifiers should be
turned down first followed by the power switches of the amplifiers. After that, the
other appliances can be turned off.
Summary of Contents for SONA SUB II
Page 2: ......
