2
Kamstrup A/S • 55121312_E1_GB_09.2015
OMNIPOWER – single-phase
Installation manual
Connect the meter in accordance with the installation diagram on the meter’s type label.
Depending on the configuration, a fixed value is displayed, or the display changes be-
tween selected indications every 10 seconds.
It is possible to change the display reading manually by activating the push button on the
meter. The available readings depend on the meter’s configuration.
Security and installation guidelines
The meter is only to be used for measuring electrical energy and shall operate within the
specified values only.
The meter must be disconnected when working on it. It can be highly dangerous to touch
the meter parts when the meter is switched on.
Therefore, the relevant security fuse must be removed and kept in a place where it can-
not be inserted by unauthorized persons.
Current local standards, guidelines, regulations and instructions must be observed. Only
authorized personnel is permitted to install electricity meters.
Meters for direct connection must be protected against short circuit by a security fuse in
accordance with the maximum current stated on the meter.
Failing to obey the ”Guidelines for safety and installation”, the guarantee no longer ap-
plies.