7
PEGS
The awning comes complete with general purpose pegs. These will be suitable
for many sites but there will be some instances where different pegs will be
necessary. Your dealer will stock a range of pegs suitable for different types of
ground. For maximum effectiveness, pegs should be driven into the ground at a
45°angle away from the pegging point.
RAIN
We make our awnings as resistant to the weather as possible. Occasionally you
may find slight leakage. This is not a fault with the manufacturing process or
materials and can normally be rectified by spot treating the seam with seam
sealant (see below).
SEAMS
The main seams of this awning have been factory taped to help prevent
leakage. Depending upon your expectations, it may be necessary to treat the
remaining seams with a seam sealant. Seam sealant should also be applied to
areas where the taping is damaged or has peeled away through wear and tear.
It can also be applied to areas where a leak may have developed. Seam
sealant is available through your dealer.
SUITABILITY
This awning is designed for use in light to moderate weather. During very strong
winds or snowfall we recommend that you take your awning down. The awning
is designed for occasional use; it is not designed for static or commercial use.
UV DEGRADATION
Awning fabrics can be weakened by prolonged exposure to sunlight. Under
normal holiday use your awning will give long service but use for extended
periods in strong sunlight will soon cause deterioration. In those cases it would
be wise to use a site as shaded as possible. UV degradation is not covered
under the warranty. The warranty does not cover awnings used on permanent
sites, displays or for commercial purposes.
CONDENSATION
Awnings contain a high proportion of synthetic materials and under
certain conditions will be effected by condensation inside the awning.
This should not be confused with leaking. Condensation can be improved
by ensuring adequate ventilation. The awning comes with various
ventilation ports that can be opened and it may also help to keep a door
open when the weather allows. Condensation and its effects are not
covered under the warranty.
SAFETY
DO NOT COOK IN THE AWNING OR USE NAKED FLAMES. READ AND
UNDERSTAND THE FIRE PRECAUTIONS LABEL SEWN INTO THE INSIDE
OF THE AWNING.
8
DEFLATION
To pack away the awning:
1. Remove the optional inner tent, if fitted.
2. Close all window blinds
3. Remove the groundsheet, if fitted.
4. Close the doors.
5. Un-peg the guy lines and tie them neatly to avoid future tangling.
6. Un-peg the intermediate pegging points but keep the four corners in place.
7. Open the valves on each pole. The awning will start to deflate. Wait until
most of the air has been expelled.
8. Un-peg the four corners.
9. Fold/roll the awning towards the deflation valves to expel more air and then
roll to fit in the carry bag.
10. Ensure that the awning is totally dry before storing in a cool, dry, dark space:
if possible opened out.
CARE
Awnings are best stored opened out. Air fully and ensure it is totally dry before
packing away. Store in a well ventilated dry place. A wet/damp awning will de-
velop mildew surprisingly quickly.
Dirty awnings can be washed using clean water and a soft brush. Do not scrub
and never use detergents.
The AirPoles do not need any maintenance but should be protected from dam-
age during storage. Damage due to improper use, wind damage or neglect is
not covered under the warranty. Have any damage repaired at the first oppor-
tunity.
Zips should be treated with care, use two hands to close and open and never
tread on them. Never force a zip. We strongly recommend that you carry a
comprehensive spares kit including silicone waterproof spray, seam sealer and
tape for repairing the AirPoles.
Repairs to the awning should be made by a company recommended by Kampa
or your supplying dealer. Repairs and alterations made by an unauthorised
company may invalidate your warranty.
