Kampa Fog Grey, Installation Manual

Page: 7 / 56

4445103585 7
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express per-
mission from the manufacturer
• Use for purposes other than those described in
this manual
Kampa reserves the right to change product
appearance and product specifications.
Using the windbreak
Before first use
Familiarize yourself with the product by carrying
out a test set up before the product is used for the
first time. Check if the scope of delivery is
complete.
Choosing a site
1. Choose a flat site for stability.
2. Choose a shaded site to avoid UV degradation
of the fabric.
3. Avoid pitching under trees as falling branches,
resin, etc. can damage the product.
4. Clear the site of sharp stones and debris.
5. Set up the windbreak with the opening facing
away from the wind.
Setting up the windbreak
I
Keep the following tips in mind while setting up the
windbreak:
• The illustrations provide a general overview of
the set up. The actual set up will vary slightly
based on the model of windbreak.
• Get help. The set up is easier with more people.
• Peg the guy lines so that the windbreak is under
tension without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the windbreak as follows:
1. To protect the windbreak from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the windbreak.
3. Separate and identify the different compo-
nents.
4. Proceed as shown to set up the windbreak
(fig.
1
, page 3 to fig.
6
, page 5).
Dismantling the windbreak
1. Remove all dirt from the windbreak.
2. Reverse the set-up procedure.
3. Ensure that all parts are clean before packing
them into the carry bag.
4. If the windbreak is wet or damp, dry fully as
soon as possible.
Storing the windbreak
I
1. Clean the windbreak.
2. Air fully and ensure the windbreak is totally dry
before packing away.
3. Store in a well ventilated dry place.
NOTE
• The supplied pegs will be suitable for
many sites but for some types of
ground special pegs will be needed.
Ask your dealer.
• Drive the pegs at a 45° angle away
from the windbreak into the ground.
• Peg each guy line in-line with the seam
they start from.
NOTE
• Fully set up the windbreak for clean-
ing.
• Choose a sunny day for cleaning to
ensure the material will dry thoroughly.