5
Unscrew the top cap, of the inflation valve, and
attach the pump nozzle (6). Start to pump (7).
It is not possible to over inflate the awning with
the pump supplied. An ideal inflation pressure
will be between 9 -11 psi (0.62 - 0.76 BAR), but
do not worry about the pressure when using a
Kampa supplied pump as they can not
physically over inflate the awning. Pump as
much air as you can.
Once the poles have inflated it will be necessary
to lift the front of the awning (8) so that it
assumes the correct shape (9).
Give the awning a few more pumps until the
poles feel hard to the touch. As mentioned
before, an ideal pressure will be between 9-11
psi (0.62 - 0.76 BAR). If necessary take a rest
before adding more pressure.
Close all doors and entrances. Peg the front
corners (10) ensuring that you pull the awning
forward away from the caravan and the front
corners away from each other to create some
tension between them.
Make sure that the awning is sitting squarely on
your caravan, if necessary adjust the pegging at
the four corners ensuring that the sides and
front are stretched tight.
The pegging points have a range of possible
pegging options. Select a point that puts the
awning under tension but without over stressing.
Peg the intermediate pegging points. Once
completed the awning should look taut without
too many creases - if necessary readjust the
pegging and if the poles are bent increase the
pressure.
Once you are happy with the pressure screw on
the inflation point cap until it is tight to prevent
leakage.
6
7
8
10
9
6
GUY LINES
The Fiesta comes with guy lines pre-attached.
We recommend that these guy lines are used at
all times (11). Peg the guy lines so that the
awning is under tension without distorting the
shape, they should run in line with the seams.
The guy lines can be adjusted using the runners.
Guy lines should be secured using suitable pegs
- see above. DO NOT allow children to play
around your awning. Guy lines are a trip hazard.
PEGS
The awning comes complete with general
purpose pegs. These will be suitable for many
sites but there will be some instances where
different pegs will be necessary. Your dealer will
stock a range of pegs suitable for different types
of ground. For maximum effectiveness, pegs
should be driven into the ground at a 45° angle
away from the pegging point. CAUTION: Pegs
can be sharp. Do not allow children to play
around the awning and ensure that suitable
protective footwear is worn.
SEALING BUMPER PADS
To help create a seal between caravan and
awning the Fiesta has sealing bumper pads (12)
sewn to the rear panels. Using the rear pegging
points, these bumpers should be pulled towards
the caravan. An improved seal can be
maintained by use of the optional rear upright
pole set. Insert the top of each pole into the
pocket in the top rear corner, adjust the height to
bring the pole under tension and then secure the
pole to the bumper pads using the tie tapes.
DRAUGHT SKIRT
The supplied draught skirt should be pulled
through the awning rail at the bottom of your
caravan (13). The ropes at the top corners can
be tied to the caravan chassis to make the skirt
taut.
WINDOW BLINDS
The Fiesta Air has blinds to cover each window.
The blinds can be rolled downwards and secured
using the tie tapes supplied.
12
13
14
11
