background image

   

Fiesta AIR & Fiesta AIR Pro

 

280, 350 & 420 
Instructions & care manual 

Some of the images shown in these instructions are other similar Kampa awnings and 

are for illustration purposes only. 

The Fiesta is a registered design exclusive to Kampa UK Limited 

 2 

IMPORTANT - PLEASE READ:  

 

Under  certain  conditions  all  awnings  will  suffer  from  internal  condensation.  
Depending  upon  the  atmospheric  conditions,  the  weather  and  the  amount  of 
moisture  in  the  ground,  the  condensation  could  be  quite  severe  and  is 
commonly mistaken for leaking, especially as it can run down the inside of the 
roof  and  drips  off  ties  tapes  and  other  internal  fittings.    If  you  suspect  your 
awning  is  leaking  it  is  almost  certainly  condensation.      Laying  a  waterproof 
groundsheet  (not  a  breathable  carpet)  throughout  the  whole  awning  will  help 
and condensation can also be improved by ensuring adequate ventilation.  On 
some  awnings  we  offer  an  optional  roof  lining  that  can  also  help  prevent 
condensation  and  catch  any  drips  of  condensation  that  fall  from  the  roof. 

 

The  awning  material  has  a  waterproof  PU  coating  over  its  entire  surface  and 
the  main  seams  of  your  awning  have  been  factory  taped  to  help  prevent 
leakage.  Depending upon your expectations, it may be necessary to treat the 
remaining  seams  with  a  seam  sealant.    Seams  treated  with  seam  sealant 
cannot leak.  Seam sealant should also be applied to areas where the taping is 
damaged or has peeled away through wear and tear.  It can also be applied to 
areas where a leak may have developed.  Seam sealant is available from your 
dealer. 

 

The  awning  beading  is  sewn  to  the  awning  with  a  special  waterproof  sewing 
thread.   This thread swells when wet to fill the needle holes but thread needs 
to become wet several times before it is totally effective.  This process is known 
as ‘weathering’ and it may take several soakings for the weathering to be fully 
effective. This area can also be treated with seam sealant.

 

WELCOME 

Thank  you  for  purchasing  your  Kampa  awning.    Please  read  these 
instructions  carefully  before  attempting  to  set  up  your  awning  and  retain  for 
future  reference.    If  used  properly,  your  awning  should  give  you  years  of 
trouble  free  use.    We  recommend  that  your  awning  is  insured  against 
accidental and storm damage as this is not covered by the warranty.   

This awning is designed for use in light to moderate weather.  During strong 
winds  or  snowfall  we  recommend  that  you  take  your  awning  down.    The 
awning is designed for touring use; it is not designed for semi-static, static or 
commercial use.

 

 
We recommend a trial run before using your awning for the first time.  This will 
allow you to familiarise yourself with the awning, its set up and any limitations 
the awning may have for your particular use.  Please also check your caravan 
awning rail to ensure that it is not damaged or has any sharp edges that could 
damage your awning. 

Summary of Contents for Fiesta AIR Pro 280







Reviews: