•
To adjust the length of the pole, loosen the adjustment ring nut
•
Pull out the extension to the desired size and hold it in place
•
Tighten the pole adjustment ring nut until it is locked.
13.
Early working procedures
Wear suitable gloves and clothing before using this tool. Check the tool before working
and verify the correct operation of the switch. The chain must stop when the trigger is
released. Do not use the chainsaw if the switch fails. Check that the battery voltage
matches the tool voltage.
The engine stops when the trigger is released, but the chain will continue moving by inertia
for a few seconds. Do not touch the chain while it is moving to avoid the risk of injury or
wounds.
WHEN USING THE TOOL FOR THE FIRST TIME AND EACH TIME THE CHAIN IS CHANGED,
RUN THE CHAIN FOR A FEW SECONDS WITHOUT CUTTING.
CHECK CHAIN TENSION AND, IF NECESSARY, ADJUST THE TENSION TO AVOID RISK OF
INJURY