39
13.1
Tying procedure
•
When the equipment is operating, keep your other hand at least 5cm away from the area of
tying mouth; don’t place your hand in the tying mouth.
•
Don’t use the equipment to tie the branches with a diameter more than 25mm, otherwise the
machine may get stuck. During tying operation, the tying machine has to be be vertical to
branches, and don’t tilt or move during tying process. The damage of the equipment caused by
incorrect operations is not covered by quality warranty.
•
Don’t use the equipment during rainy
days.
•
After daily usage, it is suggested to disconnect the battery to the machine and place them
together in the toolbox.
•
According to the size of actual branches to be tied, adjust gear switch with the buttons place on
the tying machine, so as to achieve the best branch-tying effect.
•
Place the hook in the correct position according to the picture, you should always put the
branch attached to the outer end of the hook, never attached to the tying helix
No. on display
Maximum Ø with plastic wire
Maximum Ø with paper wire
3
25mm
24mm
4
25mm
22mm
5
24mm
18mm
6
22mm
14mm
7
20mm
Not recommendable
8
16mm
Not recommendable
In case tying operation speed becomes slow, please check if battery charge is used up.
Correct branch position
Incorrect branch position
https://www.kipogeorgiki.gr
18
ο
χλμ
.
Ν
.
Ε
.
Ο
.
Α
.
Κ
. -
Τηλ
. 210 5573739