Kambrook KSK220, Instruction Booklet

Page: 8 / 12

7
Using Your Kambrook Profile 1.7L Kettle
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended before the first use
to fill the kettle to the maximum level
with cold tap water, bring to the boil
and then discard the water. Your kettle
will only operate when positioned
on the power base with the ON/OFF
switch in the ‘ON’ position. The kettle
will automatically switch off once the
water has boiled.
Operation Of Your Kettle
1. To fill the kettle with water, remove
it from the power base and open
the lid by pressing the button on
the handle of the kettle and the lid
will lift upwards. Fill with the desired
amount of water. Do not operate
the kettle without water. Always fill
the kettle between the minimum
and the maximum marks on the
water window. Too little water will
result in the kettle switching off.
2. Ensure that the lid is closed
before placing the kettle on
the power base.
3. Place the kettle firmly onto
the power base and plug the
power cord into a 230V or 240V
power outlet and switch on.
4. Press the ON/OFF switch to the
‘ON’ position. The power ‘ON’ light
will illuminate.
NOTE: Never operate the kettle
dry - too little water will result in the
kettle switching ‘OFF’.
Do not overfill the kettle - filling
above the maximum mark on the
water window may result in boiling
water splashing from the kettle.
NOTE:
This kettle must only
be used with the power base
supplied. Use caution when
pouring water from your kettle,
as boiling water will scald. Do
not pour the water too quickly.
NOTE: Do not remove the kettle
from the power base during
operation. Ensure the kettle has
switched to the ‘OFF’ position
after the water has boiled
before removing the kettle from
the power base.
5. The kettle will automatically switch
‘OFF’ once the water has boiled.
Lift the kettle from the power base
and pour the water. Take care to
hold the kettle level, especially
when filled to the maximum level.
To re-boil it may be necessary to
wait for a few seconds to allow the
control to reset.
6. The kettle should be stored on
its power base when not in use.
The power outlet should be
switched off and the power cord
unplugged from the power outlet
when not in use.