8
Using Your Ceramic Tower Heater
Setting the Heating Mode
To activate the heater, press the On/
Off
button. The heater will start
operating on the HIGH heat setting
(1800 watts) and the LCD screen will
illuminate, displaying the ambient
room temperature and heat setting.
NOTE:
After several seconds,
the LCD screen will fade, but
the heater settings will remain
visible.
Use the MODE
MODE
button to select the
desired heat setting. The mode button
allows you to scroll through the various
heating modes.
HIGH – High heat setting (1800 watts)
LOW – Low heat setting (900 watts)
AUTO – for use with the electronic
thermostat
FAN – for fan only operation
To switch the heater into standby
mode, press the On/Off
button.
Turn the heater off by switching the
Power
switch located on the right
hand side of the base, to the off
position.
Remove any promotional material or
packaging from the heater.
Unwind the cord to its full length
and place the heater on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and outlets
to ensure there are no blockages.
When unpacking the heater, check
to see you have received the remote
control, before discarding the
packaging.
Turning Your Heater On
Plug the cord into a 230V or 240V
power point and switch on.
NOTE:
To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
Turn the heater on by switching the
Power
switch located on the right
hand side of the base, to the on
position. An audible beep will sound,
and the red power indicator light
will illuminate. The heater is now in
standby mode.
Using the Remote Control
Your heater may be operated using
either the control panel or the remote
control.
The remote control uses 2 x AAA
batteries. To access the battery
compartment, simply remove the
cover at the rear of the remote
control.
To operate, ensure that you point
the remote control at the heater. An
audible beep will sound with the press
of each button.
KCE440_IB_FA.indd 8
12/10/09 2:26 PM
