5
OPERATING INSTRUCTIONS
BEFORE FIRST USE
Remove any promotional material from the vacuum
cleaner.
When unpacking the vacuum cleaner check to see
you have received all the required components,
such as the hose and other accessories before
discarding the packaging.
TO OPERATE THE VACUUM CLEANER
Locate the crush proof hose and push the
connection point into the hose inlet connection on
the front side of the vacuum, until a “click” sound
is heard.
Connect the wide end of the metal wand to the
hose end, and push together firmly.
Fit the floor tool to the narrow end of the wand and
push together firmly.
Fully extend the power cord by pulling the power
plug out from the rear of the vacuum, until the
yellow tape on the cord is showing.
NOTE: Ensure that you do not over extend the
power cord – do not extend past the red warning
tape on the cord.
Plug into a 230/240V power point and switch the
power on at the power point.
To commence vacuuming, push down on the on/off
button
on/off
cord
press
& lift
up
down
on the top of the vacuum cleaner.
When vacuuming is complete, push down on the
‘on/off’ button to switch off. Turn the power off at
the outlet and then remove the power cord from
the power outlet. When removing the plug from the
power outlet, grasp the plug not the cord.
To retract the cord push down on the ‘cord rewind’
button
on/off
cord
press
& lift
up
down
on top of the vacuum cleaner.
IMPORTANT: HOLD THE PLUG END AND GUIDE THE CORD
INTO THE VACUUM DURING RETRACTION TO PREVENT IT FROM
STRIKING YOU OR THE VACUUM.
CAUTION: ALWAYS ENSURE THAT THE DUST CONTAINER
AND THE MOTOR PROTECTION FILTER ARE CORRECTLY FITTED.
NEVER OPERATE WITHOUT THE DUST CONTAINER OR FILTERS
IN PLACE.
VARIABLE POWER CONTROL
The power booster lever on the vacuum can be
used for variable power control. Slide the lever
toward the MAX marking for vacuuming hard floor
and carpet surfaces. Slide the lever toward the
MIN marking when using the crevice, upholstery
and brush tools.
