Kamasa-TOOLS K 2765, Manual

Page: 7 / 18

4. Preset Setting
The preset setting status will be saved in current setting. There are three set points.

Torque Value
- Press UP or DOWN
value.

Unit
- Press UNIT button to select torque unit or angle mode or Torque then
Angle mode.

Mode
- Press MENU button into menu and select “ MODE ” to change Peak or
Track.

Torque Mode Measurement

Angle Mode Measurement

Torque then Angle Mode
Press "UNIT" button in Angle Mode to enter "T then A" Mode. In this mode, you can preset
250.0
FT-LB
2015/01/01
P1 Peak
10:50
249.0
FT-LB
2015/01/01
P1 Peak
10:50
248.0
FT-LB
2015/01/01
P1 Peak
10:50
7
After entering Angle mode by pressing the UNIT
button and selecting your
desired units, you may start to use the angle function. When you apply the angle,
the wrench will only calculate angle degrees as the applied torque achieves 5% of
the full-scale of the torque wrench. The LCD display shows the actual applied angle
degrees. After applying angle degrees, the degree is displayed, and the display will
flash “maintain 10 seconds. The degrees can be continuously applied until reaching
the set target angle degrees. If the applied angle degrees do not reach the setting
values, the final values you apply will display the accumulated angle until clear by
pressing
CLEAR or after 10 seconds to revert back to preset.
Once powered on, you may begin using the torque wrench. After force has been
applied, the LCD will display the actual torque value. Under Peak Mode, when the set
value is not reached, the LCD will display the last torque value attained. The last
reading will flash 10 seconds, but will stop flashing if additional force is applied. If the
torque value is exceeded, the peak torque will flash for 10 seconds then the LCD will
return to display the set torque value. If the torque value equals the set value, a
vibration and buzzer will automatically function.
button to increase or decrease the