3
OPERATION INSTRUCTIONS
1 Check the handle and lock nut
(C) are tight.
2 Fit appropriate adaptor and
tighten lock nut (E).
3 Connect to component to be
removed and tighten.
4 Insert the Impact Punch (F) into
the air hammer and ensure it is
locked in place.
5 Set air hammer to a low setting
where possible
6 Insert Impact punch fully into
the impact boss (B).
7 Operate the air hammer for
5 seconds bursts starting at a
low setting.
8 Increase the impact and
vibration level as required (G).
9 Once the component has
started to move, ease off on
the physical upward pressure
being applied to ensure the
component and extractor to
not suddenly fly out.
Always hold the air hammer and extractor combination with both
hands. Do not use any trigger lock facility. Never pull towards face.
Note:
The use of an air chisel/hammer for extraction utilises high impact
and vibration levels. For this reason any component removed using this
method must be properly checked and tested for functionality before be-
ing refitted.
F
G
C
E