5. Setup for the use
4.8 Blade Cooler
The automatic blade cooling system is driven by a
self-priming electric pump (15 - fig.1). Before
starting the machine, always make sure there is
cooling liquid in the tank (1 - fig.4) which shall be
“flush” to the filter panel (2 - fig.4).
4.9 Noise
Under normal conditions of use, the EV 996
bandsaw has a noise level which is lower than 78
dB (A) while in no-load operation it is 79.0 dB (A).
Keep the above technical features and
data in the utmost consideration. Any
operation which may modify machine
performances stated by the
Manufacturer is strictly forbidden. Thus, the
Manufacturer shall not be held liable for any
damage whatsoever caused by failure to observe
these recommendations.
4.10 Control Panel (fig. 2)
1. “on/off” main switch
2. Emergency pushbutton
3. Cutting Speed Selector (Slow-Fast)
4. Fuse Carrier (24 Volt - 1 Amp)
5. Stop Pushbutton
6. Control activation pushbutton (enables the on off
trigger on the grip - has also a “reset” function after
pressing the emergency pushbutton)
7. Machine low voltage warning light
8. Machine in operation warning light
9. Activated thermal switch release warning light
(sawing machine motor is provided with a thermal
circuit breaker disconnecting power when the
temperature is too high inside the motor).
4.11 Control Pushbutton (fig. 3)
The pushbutton to the machine is placed on the grip
and is made up of a safety switch (1 - fig. 3) and a
“trigger” (2).
5.1 Electrical Connection
"
The machine is equipped with a cable. Thus, it is
necessary to mount a (new) approved plug with
the dimensions suitable for the use, on the cable
end.
"
Check that the supply group is equipped with the
ground wire as prescribed by the relevant rules in
force.
"
Furthermore, check that there is a working safety
magnetothermal switch above the supply mains
to prevent damage from short circuits or
abnormal overloads.
5.2 Cooling Liquid
"
Prepare an emulsion of water and oil: MOBIL
HYDROIL (or equivalent) in the following
percentage: 5% / 8%.
"
Mix for a few minutes, in a suitable container
and clean the tank of the machine (1 - fig. 4),
reposition the cover/filter (3 - fig. 4).
5.3 Checks and Adjustments
"
Check that the machine is perfectly stable and all
screws are properly tightened.
"
Check that guards are positioned correctly.
"
Check that the blade tension lever (6 - fig.1) is
locked.
5.4 Placing the Piece
"
Open the clamp (4 - fig. 1) acting on lever (D).
"
Insert the piece in the clamp in a stable way
without placing any loose object between it and
the jaws.
"
Position the piece holder (3 - fig. 1) and lock it
with the knob. (C).
"
Tighten the clamp action on the lever (D). Apply
a tightening pressure suitable for the type of
material and the section of the piece to be cut.
