3. Equipment
4. Machine
The benchtop band saw is supplied ready to use,
packed in a cardboard box and protected by a sheet
of cardboard.
The packing material must be disposed
of according to current environmental
protection regulations.
The machine is supplied initially with:
a band saw blade measuring 44 - 7/8” x .025 x
1/2” M2 (dual metal), 8-12 TPI.
part holder.
instruction manual.
3.1 Warranty
The machine is guaranteed for 12 months following
the date of purchase: the warranty is valid only if all
of the instructions listed on the warranty certificate
and in this manual are fully complied with.
When unpacking the machine make sure
the machine is in perfect condition and
that the package contains the parts
described; the Manufacturer shall not be
responsible for errors or missing parts following
five days after shipment.
3.2 Note
The band saw has been designed, manufactured
and protected for bench use, where it is
necessary to cut all types of metal parts having a
maximum diameter or thickness of 4 1/8”.
Any other use is excluded by the Manufacturer,
who shall be exempt from any liability for
damage to people, animals, property or the
machine itself caused by improper use.
Do not run the machine without a piece to be cut
for long periods.
Do not cut “hardened” or “cemented” steel parts.
4.1 Identification
The essential information for identifying the
machine is found on the plates located outside the
product. This essentially includes:
A) Manufacturer
B) Serial number
C) Model
D) Year of Manufacture
E) Voltage (V)
F) Power (kW)
G) Hertz (Hz)
H) Amperes (A)
I) Weight (kg)
The EC approval plate is located as shown in fig 2
ref. A.
It is strictly forbidden to remove or
damage the plates; should this occur,
always contact an authorized Technical
Service only.
For any information and/or technical explanations
regarding the machine, always indicate:
model
serial number
edition and preparation date of the instruction
manual
4.2 Description
Portable bad saw consisting of a fixed bench
pivoting head with screw lock for angle sawing,
speed regulator, work clamp and operator tool.
The machine may be used for dry cutting (from 0°
to 45° right) of materials compatible with the
specifications listed below, in full respect of the
environmental conditions and limitations
recommended by the manufacture and current
health and safety regulations.
The description includes the use for
which the product has been designed
built and protected; any other use or
failure to comply with the technical
parameters listed below may constitute a hazard
to people and/or property.
