Operation
The Kam Star Cluster Micro is an easy to operate star cluster laser. There are two modes of operation; Sound-to-
Light and Automatic. The unit can be controlled from the chassis or via the remote control. The unit is powered by
the supplied adapter. To start the unit, plug in the power supply to the back of the unit, it will begin to operate
immediately but to reach its full power, please allow between five and ten minutes to warm up. The unit will only
begin emmiting its laser effect when the key on the rear of the unit has been inserted and turned to the On position.
The unit will stop emmiting laser light if the key is removed. When you power up the unit, ensure that the laser is not
pointing towards anyone’s eyes. Pressing the mode button on the front of the unit for 2.5 seconds will turn the unit
Off/On.
Auto mode
When the unit is working in Auto mode, it runs through a series of pre-programmed patterns. To activate Auto mode,
click the Mode Select button on the front of the unit or choose ‘Auto’ on the remote control. When the unit is
operating in Auto mode, the indicator LED light on the front of the unit will glow red.
Sound-to-Light mode
The unit has a built-in microphone that monitors any loud ambient sounds, including music. The laser then reacts to
this sound and displays a lightshow that matches the rhythm. To activate Sound-to-Light mode, click the Mode
Select button on the front of the unit or choose ‘Music’ on the remote control. When the unit is operating in Sound-to-
Light mode, the indicator LED light on the front of the unit will glow blue. You can adjust the sensitivity of the
microphone on the remote by choosing ‘Music’ mode and then pressing any number between 1-9 (1 is the least
sensitive and 9 is the most sensitive).
Manual mode
The unit can be controlled in Manual mode via the remote control by clicking on the third row buttons A, B or C
(G).
The A button controls the units red strobing, this is adjusted using the buttons 1-9. The B button controls the unit’s
second colour strobing, this is adjusted using the buttons 1-9. The C button controls the units effect speed, this is
adjusted using the buttons 1-9. The bottom right button
(H)
controls the effect rotation.
Remote control
The unit can be operated by the supplied remote control. Make sure the unit is powered up and working, if no lasers
are showing, press the red power button on the remote
(A)
. Use this button to place the unit in standby mode when it
is not needed. To completely turn the unit off, remove the power supply. The remote control’s
Auto
button
(C)
sets
the unit to Auto mode (see above). The
Music
button
(B)
sets the unit to Sound-to-Light mode (see above). The two
outer buttons in the second row of the remote
(D and E)
control the colour that the unit displays. The middle button
of the second row
(F)
pauses the effect.
