Operation
There are three ways to operate this unit:
Auto mode
Sound activated (Sound-to-Light) mode
Via a universal DMX controller
Master/Slave mode / Standalone operation
Auto mode and Sound activated (Sound-to-Light) mode
To operate the unit in either of the above modes, use the Function Setting buttons on the rear of the unit. Start by pressing the Menu
button to select your desired effect from the table below e.g. A1 mode (Auto 1 red), then use the Up and Down buttons to select the
speed of the effect 1-9 (slow to fast). Then press the Enter button to save your changes.
Manual setting mode:
A1 Mode
Red setting
Speed 1~9
A2 Mode
Green setting
Speed 1~9
A3 Mode
Blue setting
Speed 1~9
A4 Mode
White setting
Speed 1~9
A5 Mode
Auto setting
Speed 1~9
A6 Mode
Auto setting (not flash)
Speed 1~9
A7 Mode
Auto setting (flash)
Speed 1~9
S1 Mode
Red setting
Speed 1~9
S2 Mode
Green setting
Speed 1~9
S3 Mode
Blue setting
Speed 1~9
S4 Mode
White setting
Speed 1~9
S5 Mode
Sound active setting
Speed 1~9
S6 Mode
Sound active setting (not flash)
Speed 1~9
S7 Mode
Sound active setting (flash)
Speed 1~9
d Mode
DMX setting (5 channels)
H Mode
DMX setting (6 channels)
Universal DMX controller operation
When using a universal DMX controller to control a chain of units, you have to set the address using the DMX table below.
Master/Slave operation
Multiple units can be linked together in a daisy chain and operated in Master/Slave mode. Please use a 3 pin XLR cable/plug when
connecting multiple units together in Master/Slave mode.
Master
unit: select Auto or Sound mode on the Master unit.
Slave
units: select DMX mode and set the start address to
d001
.
In Master/Slave mode please refer to the DMX settings using the table below.