Features of the KWM Quartet receiver (front)
1. Antenna socket (channels C & D)
2. Power switch
3. Channel D power Indicator
4. Channel D radio frequency indicator
5. Channel D signal level indicator
6. Channel D volume control
7. Channel C volume control
8. Channel B volume control
9. Channel A volume control
10. Antenna socket (channels A & B)
Features of the KWM Quartet receiver (rear)
1. Channel A output - balanced XLR
2. Channel B output - balanced XLR
3. Channel C output - balanced XLR
4. Channel D output - balanced XLR
5. Mix output - unbalanced 6.35mm jack
6. USB charger output (5V / 500mA)
7. DC power adaptor socket
Features of the USB rechargeable microphone
1. Grille covering microphone element
2. LED status indicator
3. Power switch (on/mute/off)
4. Battery compartment cover
5. Coloured ring indicator
6. Recharging socket
Battery compartment cover removal
Unscrew the coloured ring at the base of the microphone.
Remove ring and slide battery compartment down.
Charging the microphones
Ensure the rechargeable batteries have been correctly installed. Only use rechargeable Ni-MH batteries.
Do not use standard non-rechargeable batteries as this may result in damage to the equipment.
Plug the USB recharging lead (supplied) in to the USB socket on the rear of the KWM Quartet receiver.
This allows charging of two microphones at any one time.
Plug the other end of the USB charging lead in to the socket on the base of the microphone. The LED status light
on the microphone will light up GREEN when charging is complete. Allow the microphones to charge fully before
removing the charging lead. Charge time from empty is approximately 5 hours.
If microphones are not going to be used for an extended period of time please remove the batteries to prevent
damage and corrosion.
