Kam KHD2000
Rackmount dual USB media player
Thank you for purchasing this product, we are sure that it will serve you for many years to come.
To optimise the performance of this product, please read these operating instructions carefully to
familiarise yourself with the basic operations of this unit. This unit has been tested at the factory before
being shipped to you. To prevent or reduce the risk of electrical shock or fire, do not expose this unit to
high temperature and rain or moisture.
Unpacking and safety:
Please unpack your new product carefully, your new product should reach you in perfect
condition. Please check that no damage has occurred during transit. If any damage is found, do not operate your
unit. Please contact the retailer you purchased it from immediately. If there is any damage to the mains cable do
not use the device. Always disconnect the unit from the mains supply when carrying out any servicing or cleaning
of the unit. Select the installation location of your unit carefully. Avoid placing it in direct sunlight or locations
subject to vibration and excessive dust. Keep away from sources of hum such as transformers or motors. Do not
use unit where there are extremes in temperature (below 41ºF / 5ºC or exceeding 95ºF / 35ºC).
1. USB PORT
Hook up a USB device to load the music. If using a hard drive, make sure that the unit is self
powered as the USB power supply of the KHD2000 may be insufficient. The maximum current of each USB
connection is 500mA. The USB ports support Mp3 format only.
2. SEARCH
Press this button and use the jog wheel to perform playback, fast searching forwards or backwards.
Press and hold this button. Rotating the jog wheel will perform track skip whether in Play or Stop mode.
3. JOG WHEEL
Use the jog wheel to adjust the tempo to beat match with another track. The jog wheel can also be
used to trim the loop (longer or shorter). The jog wheel can also be used to skip through the song or find individual
segments by going through frames. Combine the jog wheel with the Search knob to find a certain track.
4. TRACK/ENTER
Use this button to select ports, folders, partitions, and songs. Turn to swap between each folder,
partition or song. By default both players are set to read the center (primary) USB port. The left USB port is an
additional port, to select, turn the Track/Enter knob. When you plug a flash drive into either port, keep pressing the
Track/Enter knob down go to select partitions, folders or tracks. When scrolling to the track you would like to play,
press the knob to view the track information. Pressing Play/Pause will start the music.
Partition: Scroll through the selection to find which partition to use.
Folder: After selecting the partition, scroll through options to select the folder.
Track: When selecting a folder, scroll to find a certain track you would like to play.
Pressing the Back button will return to the previous setting.
5. DISPLAY
When performing specific functions, it will show on the display.
6. MODE
Press the Mode button to select multiple functions; SINGLE/CONTINUE: Select this function for single and
continuous play. SINGLE plays one track at a time, stopping at the end of the track. CONTINOUS play is when the
unit is set to play all tracks continuously. TIME there are two functions under time, ELAPSED and REMAIN. ELAPSED
shows how much time has passed. REMAIN shows the time that is left. SCAN search the playlists saved in the
attached flash drive. In order to select tracks for the playlist, scroll to the track and hold down the TRACK/ENTER
knob to put the track into the play list. Remember that when making playlists on your computer, you should make
2
1
2
3
4
5
6
7
8
9
10
11
12
14
13
15
16
17 18
