Troubleshooting
Problem:
Condition:
Solution suggested:
Burner won’t light
Control knob is not in
Maximum position (big flame).
Turn the control knob to the maximum position
(big flame).
LPG cylinder valve is closed /
Empty.
Open the valve / Replace LPG cylinder with a new
one.
Blockage in the injector.
Clean or replace injector.
Air in the gas circuit.
Open gas line and bleed it (pressing control knob
in) for not over 1 minute or until you smell gas.
Low gas pressure.
Replace LPG cylinder with a new one.
Igniter fails.
Use match to light burner; change battery or
obtain new ignite and replace it.
Burner won’t
stay lit
Dirt build up around burner.
Clean dirt around the burner.
Low flames or not full running
around the burner.
Flame spreader holes partially closed; clean the
burner.
Thermocouple is not
operating correctly.
Replace thermocouple (FSD).
Low Gas pressure.
Replace LPG cylinder with a new one.
Burner flame is low
Note: Do not
operate appliance
below 5 ˚C
Outdoor temperature is
greater than 5 ˚C and LPG
cylinder is less than 25 % full.
Replace LPG cylinder with a new one.
Gas pipe is bent or kinked.
Straighten hose and perform leakage test on gas
pipe.
Control knob is fully Maximum
position (big flame).
Turn control knob to”OFF” position (full disk), let
cool to room temperature and check burner and
orifices for blockage.
